Goldstar Cd player Parts — Browse All Models

Troubleshooting your Goldstar CD player when the remote control doesn't work

• Check the batteries in the remote control. Weak or dead batteries won't power up the remote device. Replace the remote control batteries if they're weak or dead.
• The remote control has an effective range of about 20-feet. Make sure that you're within range of the CD player when attempting to use the remote.
• Check for items blocking the RF sensor on the CD player and move any items out of the way to allow the CD player to receive remote control RF signals.
• The microprocessor inside the remote can fill up its internal memory or the microprocessor can get the memory scrambled at times. Reset the microprocessor and drain the memory in the remote by removing the remote control batteries and holding down one or more buttons on the remote device for several minutes. Reinstall the batteries and the remote may work normally again.
• You may need to replace the remote if it won't work after resetting the microprocessor and it has good batteries.

Top replacement parts for Goldstar CD players

• Drive belt. The drive belt spins the compact disc tray gears to extend and retract the tray for loading, removal and playback of compact discs.
• CD deck assembly. The CD deck assembly contains the main components of the CD player, including the compact disc tray, disc drive motor and gears.
• Main electronic control board. The main electronic control board governs the settings and functions of the CD player and powers the components inside the CD player.
• Remote control. The remote control communicates control and setting selections to the CD player using RF (radio frequency) signal. The remote control allows you to operate the CD player and make setting selections from a remote location.