Ryobi Miter saw Parts — Browse All Models

Replacing the motor brushes in your Ryobi miter saw

• Unplug the miter saw power cord from the electrical wall outlet to disconnect electrical power.
• Remove the brush caps using a screwdriver. The brush assemblies are spring loaded so the brushes will pop out once you remove the brush caps.
• Insert the new brush assemblies into the motor and reinstall the brush caps.
• Restore power to the miter saw.

Replacing the blade in your Ryobi miter saw

• Use only the recommended replacement blades in your miter saw. Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle. Thicker blades can prevent the blade screw from securing the blade on the spindle, resulting in serious personal injury.
• Wear work gloves to protect your hands when replacing the blade. Unplug the miter saw before replacing the blade.
• Push down on the saw arm and pull out the lock pin to release saw arm. Raise saw arm to its full raised position. Be cautious, saw arm is spring loaded.
• Loosen the screw on the blade bolt cover until the blade bolt cover can be raised. Gently raise the lower blade guard bracket, releasing the lower blade guard from the notch so that the lower blade guard and blade bolt cover can be rotated up and back to expose the blade boll.
• Hold the spindle lock button in and remove the blade bold and washer then remove the blade.
• Install the new blade on the spindle and reassemble the saw.