Craftsman 152213371 dust collector Parts

For Craftsman model 152213371, cleaning the filter means removing the filter media (bag or cartridge style, depending on your setup), emptying the collected dust, and reinstalling it so airflow stays strong. Follow the maintenance steps and safety notes in the owner's manual.

• Disconnect the unit from power before servicing.
• Remove the filter (or filter bag) carefully to avoid tearing.
• Empty debris into a trash can; tap gently to loosen packed dust.
• Brush off the surface with a soft brush; avoid aggressive scraping.
• If your filter is washable, rinse with cool water only and let it dry completely before reinstalling.
• Reinstall the filter so it seals evenly; a poor seal reduces suction and increases dust blow-by.

• Do not run the vacuum/dust collector with the filter removed.
• Do not reinstall a damp filter; it can clog quickly and may cause odor or reduced airflow.
• Do not use compressed air at close range; it can rupture filter media.

A clean, properly seated filter protects the motor and keeps airflow (CFM) up. When the filter loads up with fine dust, performance drops fast and the unit works harder than it should.

Last updated: February 2026

The model number for your Craftsman dust collector is printed on the product’s specification label; for this unit it’s MODEL NO. 152.213371. You’ll typically find that label on the motor/blower housing or the main frame where it’s easy to read during service. For label locations and diagrams, use the owner's manual.

Check these common label spots first (with the unit unplugged):

• On the blower housing assembly near the ON/OFF switch area
• On the base or frame upright where the motor mounts
• Near the power cord entry point or circuit breaker label area
• On the side of the collector body where the safety label is posted
• On a flat surface that stays visible after assembly (not under the bags)

On Craftsman model labels, the model number is usually shown as Model No. followed by the number.

Using the exact model number keeps you aligned with the correct parts list, wiring/switch components, and accessories (like hose clamps, flexible hose, and collection bags) that fit your Craftsman dust collector.

• Copy the model number exactly as printed (including dots)
• Record the serial number from the same label
• If the label is dusty, wipe it gently so numbers are readable
• Use the model number when referencing the parts list in the manual

Last updated: February 2026

Low suction on your Craftsman model 152213371 is almost always caused by restricted airflow: a clogged hose or intake port, a full or dirty collection bag/filter, or chips and debris packed into the blower housing/impeller. Start by unplugging the unit, then clear every air path end to end using the steps in the owner's manual.

• Turn the power switch OFF and unplug the power cord before servicing.
• Make sure the intake port cap is installed whenever a hose is not connected.
• Empty and clean the filter and collection bags.
• Check the hose and fittings for a plug of chips or dust.
• Inspect the blower housing/impeller area for packed debris.
• Blow dust off the motor housing using low-pressure air only (keep air pressure under about 50 PSI).

1. Start at the nozzle/hose end: remove the hose and look through it toward a light; clear any blockage.
2. Check the intake port: confirm it is not capped while you are trying to vacuum; confirm the cap seals when stored.
3. Check the bags/filter: if suction improves right after cleaning, the restriction was in the filtration/collection.
4. Check the blower housing: chips or debris in the blower housing/impeller will reduce airflow and can also overload the motor.

Restricted airflow does not just reduce pickup; it can make the motor run hotter and overload the circuit. Keeping hoses, bags, and the blower housing clear protects suction performance and helps prevent repeated shutdowns.

Last updated: February 2026