Briggs & Stratton 28M707-0126-01 engine Parts

Yes. We still offer replacement parts for Briggs lawn and garden engines, including the Briggs 28M707-0126-01. The best match comes from using your full engine model and type code, then selecting the exact part from the parts list for your engine.

• Match the full model number exactly: 28M707-0126-01.
• If your engine tag also lists a type and code, use those too (they narrow down revisions).
• Compare the old part to the listing (shape, mounting holes, connector style, and hose size).
• Replace common maintenance items together (air filter, fuel filter, oil filter) to prevent repeat issues.
• If the engine runs poorly after storage, start with fuel system basics before replacing ignition parts.

Using the exact engine identification prevents ordering a part that looks close but does not fit. On small engines, small differences in carburetor fittings, ignition parts, and gasket sets can change by type code.

Last updated: February 2026

The Briggs 28M707-0126-01 is the engine model itself; it’s a Briggs single-cylinder, air-cooled, 4-cycle gasoline lawn and garden engine. When you’re matching parts, always use the full model number 28M707-0126-01 so the ignition, fuel, and starting components fit correctly.

This model number identifies the exact engine build and its original configuration (spec and type). That matters because small differences can change which magneto, starter, or carburetor parts fit.

Common identifiers you’ll use when servicing this engine:

• Model: 28M707 (engine family)
• Type/spec: 0126-01 (exact build)
• Application: lawn and garden equipment engine (vertical-shaft style is common in this family)

If you’re trying to confirm what you have by components, these are the most common “tell” parts to check on a 28M707-0126-01:

• Fuel system: Briggs & statton fuel filter (red) 298090S
• Ignition: Briggs & statton magneto 591459
• Starting system: Briggs & stratton lawn & garden equipment engine starter motor 497595
• Air intake: Briggs & statton air filter 496894S
• Flywheel interface: Briggs & statton key 222698S

Using the exact engine model and type (28M707-0126-01) prevents ordering the wrong ignition or starting parts, which are the most common fit issues on small engines.

Last updated: February 2026

For the Briggs & Stratton 28M707-0126-01 lawn and garden engine, we use SAE 30 for typical warm-weather mowing, or 10W-30 when temperatures vary and you want easier starting in cooler weather. Fill only to the FULL mark on the dipstick on level ground; do not overfill.

• SAE 30: Best for consistently warm outdoor temperatures
• 10W-30: Good all-around choice for changing temperatures
• Synthetic 5W-30: Helps with cold starts and provides strong high-heat protection

Oil capacity varies by the exact engine configuration and oil change method. We use the dipstick as the final authority: add oil slowly and stop at the FULL mark with the engine level.

• Park on a flat surface and let the engine cool
• Drain old oil completely, then reinstall the drain plug securely
• Add oil in small amounts, checking the dipstick often
• Stop at the FULL mark (not above it)
• Run the engine briefly, shut it off, then recheck and top off if needed

Correct viscosity and oil level protect internal parts like the crankshaft and connecting rod under load. Low oil causes overheating and rapid wear; overfilling can cause smoking, plug fouling, and hard starting.

If you are servicing the engine at the same time, these parts on our list are commonly replaced:

Last updated: February 2026