Snapper Lawn vacuum Parts — Browse All Models

Rebuilding the carburetor on your Snapper lawn vacuum engine

• Move the lawn vacuum to a well-ventilated area and disconnect the spark plug wire.
• Remove the air filter housing and drain the fuel tank.
• Remove the blower housing and take a digital picture of the carburetor choke and throttle linkage connections. Remove the carburetor and place it on a clean work surface.
• Remove float bowl drain plug and drain fuel from the float bowl into a fuel-safe container. Remove the float bowl and reinstall the float bowl drain plug.
• Remove the float and needle valve. Pry out the main jet. Remove the O-ring from the outlet port. Remove the air cleaner gasket.
• Clean all carburetor parts using carburetor cleaner. Wipe down the carburetor.
• Reassemble the carburetor using the seals, gaskets and parts from the carburetor rebuild kit.
• Reinstall the carburetor on the lawn vacuum engine.
• Reassemble the lawn vacuum engine and connect the spark plug wire.

Maintenance and storage tips for your Snapper lawn vacuum

• Never disable or tamper with safety devices on your lawn vacuum. Repair any safety device that malfunctions.
• Check bolts, screws and fasteners for proper tightness before every use to keep the lawn vacuum in safe working condition. Tighten any loose fasteners before using the lawn vacuum.
• Don't change engine governor settings to speed up the engine. The governor is set to run the engine at maximum safe operating speed.
• Follow the instructions in the owner's manual to safely store your lawn vacuum during the off-season. Add fuel stabilizer to the tank during your final use before storing to prevent carburetor damage.
• Perform a tune-up on the engine before storage so the lawn vacuum is ready to go for the next season.