Estate has been manufacturing top-quality side-by-side refrigerators for many years. Estate side-by-side refrigerators offer convenient storage features and dependable cooling systems. When your Estate side-by-side refrigerator breaks down, trust Sears PartsDirect to have the repair parts you need to get your refrigerator going again quickly.
Replacing the water inlet valve in your Estate side-by-side refrigerator
Safely store any food that could deteriorate while the refrigerator is shut off. Then unplug the refrigerator or shut off the circuit breaker for the refrigerator. Close the water supply cut-off valve for the ice maker. The valve is often on the wall behind the refrigerator, but could be attached to a water pipe under the kitchen sink or in the basement below the fridge.
Pull the refrigerator away from the wall far enough so you can access the water line connection and work on the back of the refrigerator. Place a towel under the water valve assembly to catch water. Loosen the nut on the supply water line until the water line is free.
Use a Phillips screwdriver to remove the screws that secure the lower service panel on the back of the refrigerator. Remove the panel. Remove the screw that secures the mounting bracket to the frame of the refrigerator. Press the back of the locking tab on the wire harness to release the tab. Pull the wire harness plug off the valve. Remove the black plastic C-clip from the collar of the water line connection. Push the collar in and simultaneously pull the water line from the inlet water valve assembly.
Push the water line into the fitting on the new water valve assembly. Reinstall the C-clip on the collar of the fitting. Push the wire harness plug back onto the spades of the water valve assembly. Push the plug in until the locking tabs snap into place. Position the bracket of the new valve assembly so that the mounting holes line up. Reinstall the mounting screw and tighten firmly. Position the lower service panel on the back of the refrigerator so that the screw holes line up. Insert the screws and tighten firmly.
Wrap a small amount of pipe thread tape around the water supply line fitting on the back of the water valve. Fit the water line into the water valve assembly and tighten the compression nut firmly. Open the water supply cut-off valve. If the fitting leaks, tighten the compression nut and check again. Plug in the refrigerator or turn on the house circuit breaker to restore power.
Diagnosing thermistor problems in your Estate side-by-side refrigerator
If the fresh food section of your refrigerator isn’t cooling properly, you could have a problem with the appliance’s thermistor or temperature sensor. The electronic control board monitors the thermistor and controls the refrigerator temperature based on thermistor signals. A broken thermistor could send the wrong information to the control board, resulting in a refrigerator temperature that’s too cold or not cold enough.
Follow the steps in this Sears PartsDirect video to check the thermistor to see if it’s working correctly. The video also shows how to check the wires that connect the thermistor to the electronic control board to make sure the problem isn’t with the wiring or the control board.
Installation guide
Error Codes
Owner’s manual
