Official Modern Maid gas range parts

Replacing the oven door lock assembly in your Modern Maid gas range

• Carefully pull the range forward and unplug it. If necessary, have someone assist you when moving the range. Shut off the gas supply to the range.
• Remove the screws that secure the back panel to the range. As you remove the last couple of screws, press the panel against the range so it doesn't fall. Carefully lower the panel to the floor and then set it aside.
• Disconnect all the wires from the oven door lock motor assembly. Remove the mounting screws that hold the door lock assembly in place. To release the door lock assembly from the connecting rod, pull the oven door lock motor assembly down and tilt it in. Remove the door lock assembly from the range and discard it.
• Tilt the new oven door lock motor assembly and insert the connecting rod in the opening. Work the assembly into position and screw the door lock assembly in place. Carefully connect all the wires in the right location on the new oven door lock assembly.
• Position the outer back panel on the back of the range so that the holes line up and screw it into place.
• Plug in the range and push the range into position. Open the gas supply cut-off valve. Ensure that the rear leveling foot is properly engaged in the anti-tip bracket.

Cleaning grates and surface burners on your Modern Maid gas range

• Cool burners and cooktop. Allow the burners and cooktop to cool before you start cleaning.
• Soak grates and burner caps overnight. Fill your kitchen sink with about 2 gallons of water then add 3 tablespoons of grate cleaner to the water. Stir the water until the granules completely dissolve. This stuff is strong, so wear gloves and avoid getting it on your skin. If you do, rinse it off. Soak grates and burner caps overnight.
• Clean softened residue. The next day, put on some rubber gloves and drain the sink. Using a scrub brush or abrasive pad, clean softened soil and residue from the grates and burner caps and rinse everything thoroughly. Wipe the grates clean with a towel.
• Clean the burner heads. First, wipe the burner head with a damp cloth. Remove food and residue between the burner head slots using a toothbrush. To remove stubborn residue, use a paper clip or sewing needle. A small-gauge wire works also. Make sure that you clean the ignition port so the burner ignites properly. Wipe the burner head with a damp cloth after cleaning the slots and the ignition port.
• Allow all burner heads to dry and then reassemble the range.