DeWalt Wet/dry vacuum Parts — Browse All Models

Common replacement parts for DeWalt wet/dry vacuums

• Caster wheels. The caster wheels fit on the bottom of the shop vacuum canister and allow you to roll the shop vacuum to the location needed.
• Power switch. The power switch turns the shop vacuum suction motor on and off.
• Paper filter. The paper filter traps dust and lint in the canister and prevent contaminants from going out through the exhaust port.
• Foam filter sleeve. The foam filter sleeve fit over the filter cage and is used when vacuuming liquids.

Replacing the paper filter on your DeWalt wet/dry vacuum

• Unplug the power cord to disconnect electrical power from the shop vacuum.
• Release the locking tabs at the top of the canister and pull the power head assembly off the top of the canister.
• Set the power head assembly upside down and remove the filter plate from the bottom of the paper filter.
• Pull the paper filter off the filter cage and install the new filter on the filter cage.
• Reinstall the filter plate on the bottom of the paper filter.
• Reinstall the power head assembly on the top of the canister and plug the shop vacuum in to restore electrical power.