CONFIRM THE PART FITS
Part Information
This bevel gear (part number 2RVM) is for table saws.
Bevel gear 2RVM meshes with the worm gear to raise and lower the blade height.
Unplug the table saw before installing this part. Wear work gloves to protect your hands.
Top models using the same part
Model Name | Model Number | Diagram Name |
---|---|---|
Model #137054450 Craftsman table saw | 137054450 | Saw asy |
Model #JT2504RC Craftsman table saw | JT2504RC | |
Model #137218070 Craftsman table saw | 137218070 | Base assy |
Model #137284630 Craftsman table saw | 137284630 | Table assy |
Model #137218072 Craftsman table saw | 137218072 | Body/blade |
Model #137218073 Craftsman table saw | 137218073 | Saw table |
Model #137218071 Craftsman table saw | 137218071 | Base assy |
Model #137415030 Craftsman table saw | 137415030 |
Reviews
Exact fit and was easy to install
The gear on my Porter Cable that moves the blade up and down had missing teeth due to rough use.Remove the the table from the base and you can easily access this gear. The gear is held on by a single nut and bolt and is easy to replace,total time of repair should take approx 30 minutes.
Mr H, MI
Did you find this review helpful?
- Ease of Installation
- Easy
- Duration of Installation
- 30 minutes - 1 hour
Easy to install once you figure it out.
Takes about a half hour. Need a small combination wrench, hammer and schematic. Before totally removing the nut that holds the Bevel Gear shaft, tap shaft loose with hammer then take nut off. Assemble with a new spacer then dry lubricate. If you keep the Bezel Gear & Worm Gear free of sawdust (and lubricated) this won't happen again. If raising or lowering your blade starts to become difficult, you are about to break your bevel Gear. Stop and internally clean the table saw & lubricate.
DH43, Penticton, British Columbia, Canada
4 people thought this review was helpful.
- Ease of Installation
- Moderate
- Duration of Installation
- 30 minutes - 1 hour