Refrigerator Ice Maker Ice Mold 3390JA1150A

Was straightforward to install, works well. Ice releases from tray and water no longer over flows into the ice bin.

It was simple to install. A lot cheaper than buying a whole new ice maker unit. Great quality.

Not only was this part easy to install it was also an improved version that had a splash guard thus preventing water from getting into the the ice holding bucket causing the ice cubes to stick together.

Easy install less than 5 minutes exact fit works perfect.

Newer updated version solves the water overflow problem icing up all the time ...fits perfectly very easy to install no tools needed.

Perfect replacement tray. Fixed problem of cubes not ejecting. Not hard to replace, but no directions. Took a leap of faith to find the two screws needed to pull out the icemaker.

Very simple fix. Exactly the correct part. Need to include instructions with parts. There is a tiny reset hole that resets the tray after installation and it located on right side of unit where ice tray connects to small square box. Look under the little square box for reset hole and use paper clip or something similar to reset. Ice tray will immediately start to rotate and then fill. You are set.

Must have been crushed in storage and/or shipping. The two little tabs that hold the sensor cover pins were crushed almost flat. I had to take a heat gun and straighten them out. (I was afraid they would break if I tried to straighten them at room temp.) I didn't want to waste time waiting for a replacement. Luckily it works fine. I did not think to get a photo.