Craftsman 9179998C lawn mower Parts

On the Craftsman walk-behind mower model 9179998C, the model number is printed on the mower’s ID sticker. For this style of mower, the sticker is typically on the back of the deck, between the lower handle mounts; confirm the exact label location in the 9179998C owner's manual.

Check these common label locations first (starting with the most likely):

• Back of the cutting deck, between the lower handle mounts
• Rear of the deck near the discharge opening or rear door area
• Side of the deck near a wheel height adjuster
• Under the handle crossbar area (near where the handle bolts to the deck)
• On the engine shroud (engine model information, not the mower model)

For parts lookup and service, we recommend recording all of the following:

• Mower model number (example format: 917.9998C or 9179998C)
• Serial number (usually on the same sticker as the model)
• Engine model number (often on the engine label; this mower uses a Briggs & Stratton engine family)

Using the exact model number prevents ordering the wrong blade, blade adapter, wheels, or control cable. Even small model-number differences can change deck hardware and handle components.

Last updated: January 2026

On your Craftsman walk-behind mower model 9179998C, the mower’s model and serial number are on a decal on the rear of the mower housing. For the engine model number, check the engine shroud (blower housing) and nearby covers for an engine ID label or stamped code; the exact spot varies by engine.

• Mower model/serial decal: rear of the mower housing (helps us match the correct parts list)
• Engine model/type/code: typically on the engine shroud, valve cover area, or near the muffler
• Recoil starter area: look around the pull-start housing for a sticker or stamped numbers
• Under the air filter cover: some engines place ID info near the air cleaner base
• Clean first: wipe grass and oil residue so the label is readable

Write down the engine information exactly as shown (including dashes and spaces):

• Engine model
• Engine type (if listed)
• Engine code (often a date-style code)
• Any spec number or trim number

The mower model number (9179998C) identifies the deck and chassis parts, but the engine model number identifies engine-specific parts like the spark plug, air filter, carburetor parts, and ignition components. Having both prevents ordering the wrong part.

For diagrams and the exact model/serial decal location for this mower, use the 9179998C owner's manual.

Last updated: January 2026

For the Craftsman 9179998C gas walk-behind mower, we recommend using fresh regular unleaded gasoline (typically 87 octane). Higher octane (like 91) does not add power in a mower engine; the bigger fuel concern is avoiding high-ethanol gas because this mower is rated for gasoline up to 10% ethanol (E10). See the 9179998C owner's manual for the exact fuel guidance for your engine.

• Use fresh, clean, regular unleaded gasoline (commonly 87 octane).
• Use gasoline with up to 10% ethanol (E10).
• Avoid gasoline with more than 10% ethanol (often labeled E15, E20, E85).
• Avoid old fuel; gas that sits can cause hard starting and rough running.
• Keep fuel off rubber parts and tires; gasoline can damage rubber.

Your mower’s manual notes that gasoline containing up to 10% ethanol (E10) is acceptable, and using fuel above E10 can create problems and is not recommended for this machine. Ethanol-heavy fuel can contribute to starting issues and fuel-system deposits during storage.

• Store gasoline in an approved container and keep it tightly sealed.
• Buy only what you will use in about 30 days.
• If the mower will sit, run the engine dry or treat the fuel before storage.
• Keep the engine area clean; a clogged, dirty engine runs hotter and can shorten engine life.
• Before any service, disconnect the spark plug wire as described in the manual.

• How to keep lawn mower gas from going bad
• How to winterize a lawn mower

Last updated: January 2026

The model number is 917.9998C (often written without the dot as 9179998C) for this Craftsman walk-behind gas lawn mower. You’ll see it printed on the mower’s model label and on the cover of the 9179998C owner's manual.

Check these common locations on Craftsman walk-behind mowers like model 9179998C:

• On the rear of the deck near the discharge opening or rear door
• On the top of the deck near the engine mounting area
• On the handle bracket area (left or right side)
• On a sticker or metal tag that also lists the serial number

This mower uses a Briggs & Stratton engine, which has its own separate model number. Use the mower model number for chassis parts (blade, wheels, rear door), and the engine model number for engine parts (air filter, carburetor, recoil starter).

Using the correct model number helps us match the exact parts diagram and hardware for your mower. For example, the 21-inch blade and blade mounting parts are model-specific; a common match for this mower is the lawn mower 21-in deck mulching blade 532406706.

• Enter the model as 9179998C if the lookup does not accept punctuation
• Match the part description to your diagram section (deck, handle, wheels)
• Replace blade mounting hardware if it’s worn or damaged

Last updated: January 2026