Frigidaire freestanding electric range with glass touch panel

Disconnect power from the range. Check the resistance of the oven temperature sensor using a multimeter. You should measure about 1,100 ohms resistance through the sensor at room temperature. If not, replace the sensor. If the oven temperature sensor is okay and the oven continues to overheat, replace the oven control board because a stuck relay on the control board is causing the oven to overheat.

The control detects a key. Make sure nothing is pushing against the keypad. Press the Stop key to clear the display. If the code won't clear, disconnect electrical power to the range and check the wire harness connections between the touch control panel and the oven control board. Reconnect any loose wires. If the wiring is okay, replace the touch control panel. If the problem continues, replace the oven control board.

Disconnect electrical power, wait 30 seconds and restore power. If the error code returns, replace the oven control board.

Disconnect electrical power and check the wiring connections between the touch control panel and oven control board. Reconnect any loose wires. If wiring connections are okay, replace the oven control board. If the problem continues, replace the touch control panel.

Disconnect electrical power and check the wiring connection between the user interface control board and the oven control board. If the wiring connections are okay, replace the user interface control board. If the error code returns, replace the oven control board.

Disconnect power from the range. Check the resistance of the oven temperature sensor probe using a multimeter. You should measure about 1,100 ohms of resistance through the sensor probe at room temperature. If not, replace the sensor probe.

If the oven door won’t lock or unlock, disconnect power, wait 30 seconds and restore power. Try again to lock it by activating the oven lockout feature or starting a clean cycle. If the door wouldn’t unlock, try to unlock it by pressing the cancel button. If the door lock motor doesn’t run, disconnect power to the range and check the wire harness connections between the door lock assembly and the oven control board. Reconnect any loose wires or replace the wire harness if damaged. If the wiring is okay, replace the door lock assembly. If the problem continues, replace the oven control board.