Vissani Wine & beverage cooler Parts — Browse All Models

Common repair parts for Vissani wine and beverage coolers

• Electronic control board. The electronic control board receives temperature signals from the temperature sensor or sensor inside the cabinet and cycles the cooling system on and off to maintain the set temperature inside the wine or beverage cooler.
• Temperature sensor. A temperature sensor detects temperature and sends a signal to the electronic control board to help keep the wine or beverage cooler at the set temperature.
• Door gasket. The door gasket seals the gap between the door and the cabinet to prevent warm air from entering the wine or beverage cooler cabinet when the door is shut.
• Control panel. The control panel houses the control buttons and the display to allow you to set the temperature inside the wine or beverage cooler.

Reversing the door swing on your Vissani wine or beverage cooler

• Unplug the wine or beverage cooler power cord to disconnect electrical power.
• Remove the toe grill mounting screws and pull the toe grill off the wine or beverage cooler.
• Remove the upper hinge bracket cover.
• Remove the upper hinge bracket mounting screws. Support the door while removing the last mounting screw to keep from bending the door hinge pin at the bottom of the cabinet. Remove the upper hinge bracket while still supporting the door.
• Carefully lift the door off the hinge pin at the bottom of the cabinet and place the door on a padded surface.
• Move the hinge pin to the opposite side of the wine or beverage cooler cabinet.
• Install the door on the hinge pin and support the door while installing the upper hinge bracket with its pin inserted in the top of the door. Reinstall the upper hinge bracket cover.
• Plug the power cord back into the wall outlet to restore power to the wine or beverage cooler.