Kmart Lawn edger Parts — Browse All Models

Replacing the spark plug in your Kmart lawn edger's engine

• When the engine is cool, disconnect the spark plug wire from the spark plug.
• Use a spark plug wrench to loosen and remove the spark plug.
• Use a spark plug gap tool to set the gap between the center electrode and the ground electrode. The gap specifications for your model are in the owners manual.
• Thread the spark plug into the engine. Then tighten the spark plug with a spark plug wrench.
• Reconnect the spark plug wire and start the edger to make sure it runs.

Edging tips for your Kmart lawn edger

• Edging is best performed when conditions are dry. If the ground is wet when edging, dirt gets packed around the blade which can cause excessive belt wear and interfere with blade performance.
• If dirt does build up round the blade, stop the engine and disconnect the spark plug wire. Remove the dirt from around the blade.
• For deep edging, first cut a shallow trench that cut the trench deeper until the desired depth is obtained.
• For uniform edging, run the blade guide along the edge of the sidewalk or driveway.