Swisher Gas lawn mower Parts — Browse All Models

How to replace the drive cable on your Swisher gas walk-behind lawn mower

• Disconnect the spark plug wire from the spark plug.
• Pivot the cable clip up and release it from the mower handle. Release the zone control cable from the bail control bar. Release the drive cable from the drive control lever. Depress the release tabs and pull the zone control cable out of the drive cable clip. Cut the cable ties that secure the cables to the mower handle.
• Tilt the mower back to lift the front wheels then secure the mower handle to your work table to hold the mower steady as you remove bottom-mounting screws. Remove the bottom drive cover mounting screws. Release the mower handle from the work table and carefully lower the mower to the upright position. Remove the top drive cover mounting screws. Release the height adjuster lever and pull the drive cover off.
• Remove the drive cable end from the anchor post. Depress the release tabs and pull the drive cable sheath out of the transmission lever. Remove the drive cable.
• Attach the drive cable end to the anchor post. Push the drive cable sheath into the transmission lever.
• Put the drive cover in position on the mower and re-engage the height adjuster lever. Reinstall the drive cover’s top-mounting screws. Tilt the mower back to lift the front wheels then secure the mower handle to your work table. Reinstall the drive cover’s bottom-mounting screws. Release the mower handle from the work table and tilt the mower upright.
• Route the drive cable around the right side of the engine and connect the zone control cable to the drive cable clip. Reconnect the zone control cable to the bail control bar. Connect the drive cable to the drive control lever. Snap the drive cable clip back into the mower handle. Install new cable ties to hold the cables against the mower handle.
• Connect the spark plug wire to the spark plug.

Top replacement parts for Swisher gas walk-behind lawn mowers

• Carburetor rebuild kit. The carburetor rebuild kit includes gaskets, seals, a hinge pin and other components to refurbish the carburetor.
• Drive belt. The drive belt connects the engine pulley on the crankshaft to the pulley on the drive gear case. The gear case rotates the wheels to propel the mower.
• Ignition coil. Located next to the flywheel, the ignition coil generates electric current to fire the spark plug when flywheel magnets spin past the ignition coil. The ignition coil sends the electric current to the spark plug at the proper time to ignite the fuel in the cylinder.
• Starter rope. The starter rope is a heavy nylon cord that coils around the pulley of the recoil starter. The user pulls it to start the engine. The spring-loaded pulley on the recoil starter retracts the starter rope when the user releases it.