Kelvinator Wine & beverage cooler Parts — Browse All Models

Leveling your Kelvinator wine or beverage cooler

• Position the wine or beverage cooler on a flat, level surface capable of supporting the unit when it's full.
• Check vertical and horizontal leveling using a bubble or laser level.
• Adjust leveling legs to properly level the wine or beverage cooler side to side and front to back. Level the wine or beverage cooler front-to-back with a slight tilt backward so the door swings gently shut when you let it go.
• Press down on diagonally opposing corners of the cabinet to check for stability. Adjust leveling legs to eliminate any rocking.

Top replacement parts for Kelvinator wine and beverage coolers

• Leveling leg. The leveling leg adjusts to keep the wine or beverage cooler cabinet level when you install the cooler in its permanent location.
• Light switch. The light switch turns the interior light on and off when you open and close the cooler door.
• Temperature sensor. The temperature sensor detects temperature inside the wine or beverage cooler cabinet and sends a signal to the electronic control board to indicate interior temperature.
• User interface control. The user interface control allows you to select wine or beverage cooler settings.
• Compressor. The compressor is a positive displacement pump rotated by an electric motor. The compressor receives low-pressure refrigerant gas from the evaporator and rotates to compress that refrigerant to a high-pressure gas that moves through the condenser. The refrigerant gets hot when compressed by the compressor pump. The condenser is a heat exchanger that removes heat from the refrigerant gas and condenses it into a high-pressure liquid refrigerant. The high-pressure liquid refrigerant flows through the expansion device and into the evaporator that's at low pressure. The high-pressure refrigerant expands and evaporates. It absorbs the latent heat of vaporization as it changes from a liquid to a gas, which causes the cooling action in the evaporator. The refrigerant flows through the evaporator and back to the compressor where the cycles starts over.