Curtis Mathes Cd player Parts — Browse All Models

Troubleshooting your Curtis Mathes CD player when the remote control doesn't work

• Check the batteries in the remote control. Weak or dead batteries won't power up the remote device. Replace the remote control batteries if they're weak or dead.
• The remote control has an effective range of about 20-feet. Make sure that you're within range of the CD player when attempting to use the remote.
• Check for items blocking the RF sensor on the CD player and move any items out of the way to allow the CD player to receive remote control RF signals.
• The microprocessor inside the remote can fill up its internal memory or the microprocessor can get the memory scrambled at times. Reset the microprocessor and drain the memory in the remote by removing the remote control batteries and holding down one or more buttons on the remote device for several minutes. Reinstall the batteries and the remote may work normally again.
• You may need to replace the remote if it won't work after resetting the microprocessor and it has good batteries.

Common repair parts for Curtis Mathes CD players

• Remote control. The remote control allows you to operate the CD player and make setting selections from a remote location. The remote control communicates selections to the CD player through RF (radio frequency) signals.
• Power control board. The power control board in the CD player provides electrical current to the component devices inside the player.
• Tray door. The tray door covers the compact disc tray opening. The tray door opens to allow the disc tray to extend for loading a compact disc and the door shuts when the tray retracts back into the player cabinet.
• Disc tray. The disc tray holds and supports the compact disc during playback. The tray extends to load or eject a compact disc.