Mitsubishi video equipment repair and replacement parts

Troubleshooting your Mitsubishi video equipment when the remote control doesn't work

• Check the batteries in the remote control. Weak or dead batteries won't power up the remote device. Replace the remote control batteries if they're weak or dead.
• The remote control has an effective range of about 20-feet. Make sure that you're within range of the video equipment when attempting to use the remote.
• Check for items blocking the RF sensor on the video equipment and move any items out of the way to allow the video equipment to receive remote control RF signals.
• The microprocessor inside the remote can fill up its internal memory or the microprocessor can get the memory scrambled at times. Reset the microprocessor and drain the memory in the remote by removing the remote control batteries and holding down one or more buttons on the remote device for several minutes. Reinstall the batteries and the remote may work normally again.
• You may need to replace the remote if it won't work after resetting the microprocessor and it has good batteries.

Playing a disc on your Mitsubishi video equipment

• Turn on your television and select the video input mode that your video equipment is connected to on your television (HDMI In).
• If you connected the video equipment to an external audio system, turn on your audio system receiver and select the correct audio input on the receiver to play the video equipment's audio.
• Press the Open/Close button on the DVD player of the video equipment to open the disc tray.
• Position the DVD disc gently into the tray with the disc's label facing upward.
• Press the Open/Close button to close the disc tray.
• Press the Play button to play the DVD disc.