Kenmore Elite Reverse osmosis system Parts — Browse All Models

Replacing the O-ring in a leaking quick-connect water fitting on your Kenmore Elite reverse osmosis system

• Wash your hands thoroughly before handling the water fitting.
• Shut off the water supply to the reverse osmosis system. Open the faucet and bleed pressure off the water supply line.
• Disconnect the water line from the quick-disconnect fitting.
• Using a small slot screwdriver, remove the collet and O-ring from the quick-disconnect water fitting.
• Clean the port of the disconnect fitting.
• Lubricate and insert the new O-ring into the bottom of the port. Push the collet into the port until it locks in place.
• Reinstall the water line and turn on the water supply going to the reverse osmosis system.

Common Kenmore Elite reverse osmosis system replacement parts

• Water inlet filter. The water inlet filter traps large particles from entering the water treatment equipment to prevent damage and clogs.
• Inlet water seal. The inlet water seal keeps water from leaking through the water inlet connection on the water treatment equipment.
• Tank. The tank holds the water during the treatment process in the water treatment equipment.
• Water inlet cut-off valve. The water inlet cut-off valve shuts off the water supply going to the water treatment equipment.