Porter Cable Chipper/shredder Parts — Browse All Models

How to start the engine on your Porter Cable chipper/shredder

• Check the engine oil for proper level. Add oil if needed. Make sure the fuel tank is full of gas.
• Set the throttle to FULL and close the choke. NOTE: A warm engine may not require choking.
• Place one foot on the front support leg to hold the unit firmly in place.
• Pull the starter rope out to begin turning the engine over. Pull slowly at first and increase speed with each successive pull.
• After the engine starts, open the choke and move the engine throttle control to SLOW. Warm up the engine by running it for at least a minute.
• Set the throttle to FULL and begin chipping/shredding.

Common replacement parts for Porter Cable chipper/shredders

• Engine air filter. The engine air filter cleans the air entering the carburetor. Replace the air filter periodically, following the guidelines in the owner's manual.
• Carburetor. The engine carburetor mixes air and gas before the fuel mix goes to the cylinder for combustion.
• Recoil starter. The recoil starter spins the crankshaft to start the engine when you pull the rope.
• Engine gasket set. The engine gasket set includes all of the seals and gaskets for the engine on your chipper/shredder. Replace any gaskets that are damaged or leaking.