Electrolux Upright vacuum Parts — Browse All Models

Top replacement parts for Electrolux upright vacuums

• Pre-motor filter. The pre-motor filter traps contaminants from air flowing to the vacuum motor.
• Vacuum fan motor. The vacuum fan motor rotates the fan blades to create suction in the vacuum cleaner.
• On/off switch. The on/off switch controls electrical power going to the vacuum cleaner.
• Vacuum collection bag. The collection bag holds the dust and dirt the vacuum cleaner collects.
• Beater bar assembly. The beater bar assembly rotates to loosen dirt and debris so it's drawn into the vacuum. It includes the bearings that fit into the ends of the beater bar.

How to replace the beater bar in your Electrolux upright vacuum cleaner

• Unplug the power cord to disconnect electrical power from the vacuum cleaner.
• Turn the vacuum cleaner over so the bottom of the nozzle assembly is facing up.
• Remove bottom plate mounting screws and pull off the bottom plate from the nozzle assembly.
• Pull the beater bar up and disconnect the drive belt from the beater bar. Remove the beater bar from the nozzle assembly.
• Position the new beater bar in the nozzle assembly and slide the drive belt onto the beater bar. Install the new beater bar in the nozzle assembly.
• Position the bottom place on the nozzle assembly and reinstall the bottom plate mounting screws.
• Plug the vacuum cleaner in and check beater bar operation. Adjust the drive belt if necessary.