Snowblower Engine Starter Kit 33-738

10 minute install.

As close to a "Plug and play" as you can get. Works great

replace starter and starter button assemble

the power cord doesn't fit into the housing. holes in the starter button were skewed from the original

It does not fit the snowblower

Do not try to install this device on the snowblower I specified

The part fit exactly as advertised.

The starter kit arrived in a timely manner. All parts were in the kit and it proved to be easy to install.

Worked As Advertised

Installed on my 19 year old Craftsman snow blower. Easy installation and great instructions for various engine configurations. Mine was plug n play.

Electric Starter Kit Installation

This Sears Craftsman two-stage, 9 HP, 26" swath, track-drive snow thrower is 25 years old. Upon activation of the electric starter, the starter shaft would spin, but its drive gear teeth were not engaging the teeth on the flywheel. When I replaced the starter, I could see that the old starter driveshaft gear teeth had worn too far down to engage. There are four mounting bolts for the starter, two upper and two lower. Had difficulty re-installing the lower right mounting bolt due to very tight clearance. Be careful screwing in the mounting bolts, as the bolt holes are in the cast aluminum engine base, and cast aluminum is soft.

Starter for snowblower

A couple screws the old one is off. New one is on within minutes.

Very easy to install

The starter kit was great, easy install, 20 minutes or less and it works great. Hope it lasts as long as the old one.