Official Worx electric line trimmer parts

Installing cutting line on your Worx electric line trimmer

• Unplug the line trimmer power cord before installing cutting line.
• Hold the cutting spool stationary and unscrew then remove the spool cap and line spool.
• Cut a length of 25-feet of replacement cutting line.
• Insert one end of the cutting line into the center holder of the spool. Wrap the cutting line onto the spool in the direction indicated on the spool. Leave 4-6 inches of line unwound to thread through the cutting head.
• Clean grass and debris from the spool and cutting head then thread the line through the cutting head and install the spool. Reinstall the spool cap.

Common Worx electric line trimmer replacement parts

• Trigger switch. The trigger switch turns the electric motor on and off to control cutting head motion on the line trimmer.
• Cutting head. The cutting head houses the cutting line and spins to allow the cutting line to cut grass when the motor runs. The cutting head also controls cutting line length.
• Power cord. The power cord supplies electrical current to the trigger switch and motor to spin the cutting head.
• Cutting line. The cutting line that is initially installed in the cutting head of the trimmer will eventually be used up. Replacement cutting line is available in various sizes. Replace the cutting line with the proper size for your grass line trimmer.