Admiral Gas range Parts — Browse All Models

Installing a new spark module in your Admiral gas range

• Carefully pull the range forward and unplug it. If necessary, have someone assist you when moving the range. Shut off the gas supply to the range.
• Remove screws from the upper panel on the back of the range and then pull the upper back panel off the range. As you remove the last screw, press on the upper back panel to prevent it from dropping.
• Disconnect all the wires attached to the spark module. The type of locking tabs or fasteners varies by model. Release the locking tab and remove the spark module from the mounting bracket. Discard the spark module.
• Position the new spark module on the top of the mounting bracket and push it into place. The locking tab should snap into place when the module is in the right position. Connect the wires to the new spark module.
• Position the upper back panel on the back of the range and hold in in place while replacing the first screw or two. Replace all of the screws and tighten them firmly.
• Plug the range back into the wall outlet and the open the gas supply valve. Slide the range into position, making sure the rear foot of the range properly engages the anti-tip bracket.

Top replacement parts for your Admiral gas range

• Oven temperature sensor probe. The oven temperature sensor probe detects the actual temperature in the oven cavity. Replace it if it's not detecting the temperature properly, in which case the oven doesn't maintain the temperature you set. A complete failure, in which the sensor probe doesn't detect any temperature at all, usually triggers an error code on the electronic oven control board.
• Electronic oven control board. The electronic oven control (EOC) board governs the timing and execution of oven functions such as baking and broiling. It's usually in the control console and often has a digital clock on the front of its housing. Replace the electronic control board if it doesn't light up when it's supplied with electrical power, if it doesn't operate properly or doesn't properly send current to the oven igniter.
• Surface burner spark igniter switch. The igniter switch is an electrical switch on the stem of the gas surface burner control valve. This switch completes a circuit to the surface burner spark module, causing the burner igniters to spark when the burner switch is turned to the Lite position. Replace the burner igniter switch if the burners don't spark when you turn the burner control knob to the Lite position or if igniters spark constantly even when the burner knobs are in the Off position.