Lather power drill repair and replacement parts

Installing and removing the battery pack on your Lather power drill

• For best results, fully charge the battery pack before installing it on the power drill.
• Push the battery pack release button and remove the battery pack from the battery charger.
• Position the battery pack near the power drill handle and align the battery pack slots with the rails inside the power drill handle.
• Slide the battery pack into the handle and push the battery pack in until it fully seats.
• Pull the battery pack backward to make sure it's fully seated and latched in the power drill handle.
• To remove the battery pack, press the release button and slide the battery pack out of the power drill handle.

Electrical safety precautions to follow when using your Lather power drill

• The power drill plug must match the receptacle on the electrical wall outlet. Never modify the power drill power cord plug in any manner. Don't use an adapter plug with an earth grounded power drill.
• Don't expose the power drill to rain or wet conditions. Water entering the power drill will increase the risk of electric shock.
• Check the condition of the power cord before using the power drill. Repair damaged wires in the power cord or replace the power cord if it's damaged before using the power drill.
• When operating the power drill outdoors, use an extension cord rated for outdoor use to prevent the chance of electrical shock.
• If operating the power drill in a damp location or around a water source, use a GCFI protected power supply.