Protron Dvd player Parts — Browse All Models

Troubleshooting your Protron DVD player when the remote control doesn't work

• Check the batteries in the remote control. Weak or dead batteries won't power up the remote device. Replace the remote control batteries if they're weak or dead.
• The remote control has an effective range of about 20-feet. Make sure that you're within range of the DVD player when attempting to use the remote.
• Check for items blocking the RF sensor on the DVD player and move any items out of the way to allow the DVD player to receive remote control RF signals.
• The microprocessor inside the remote can fill up its internal memory or the microprocessor can get the memory scrambled at times. Reset the microprocessor and drain the memory in the remote by removing the remote control batteries and holding down one or more buttons on the remote device for several minutes. Reinstall the batteries and the remote may work normally again.
• You may need to replace the remote if it won't work after resetting the microprocessor and it has good batteries.

Connecting your Protron DVD player to the television

• Refer to the user's manual of the television for information on connecting the DVD player to the television. Follow the user's manuals instructions on selecting the type of cable and television connection jack or jacks to use when connecting the DVD player to the television.
• Turn off the DVD player and the television before connecting the DVD player to the television.
• To connect the DVD player to the television using the HDMI cable, plug the HDMI cable into the HDMI Out jack on the DVD player. Plug the other end of the HDMI cable into the HDMI In jack of the television.
• To connect the DVD player to the television using an HDMI-DVI cable and audio cable, plug the HDMI plug into the HDMI Out jack on the DVD player. Plug the DVI connector into the DVI In jack on the television. Connect the audio cable to the Audio Out jacks on the DVD player and the Audio In jacks on the television.