Official Nakamichi home theater system parts

Top replacement parts for Nakamichi home theater systems

• Fuse. The fuse in the amplifier blows when the home theater system draws too much current through the power cord because of a short circuit in an amplifier component or wiring.
• Power cord. The power cord supplies the home theater system with electrical current from the electrical wall outlet.
• Main electronic control board. The main electronic control board governs the settings and functions of the amplifier and powers the components inside the stereo amplifier.
• Remote control. The remote control communicates control and setting selections to the home theater system using RF (radio frequency) signal. The remote control allows you to operate the home theater system and make setting selections from a remote location.

Troubleshooting your Nakamici home theater system when the remote control doesn't work

• Check the batteries in the remote control. Weak or dead batteries won't power up the remote device. Replace the remote control batteries if they're weak or dead.
• The remote control has an effective range of about 20-feet. Make sure that you're within range of the home theater system when attempting to use the remote.
• Check for items blocking the RF sensor on the home theater system and move any items out of the way to allow the amplifier to receive remote control RF signals.
• The microprocessor inside the remote can fill up its internal memory or the microprocessor can get the memory scrambled at times. Reset the microprocessor and drain the memory in the remote by removing the remote control batteries and holding down one or more buttons on the remote device for several minutes. Reinstall the batteries and the remote may work normally again.
• You may need to replace the remote if it won't work after resetting the microprocessor and it has good batteries.