Official Fisher & Paykel range parts

How to fix a radiant surface element on your Fisher & Paykel electric range when it doesn't heat properly

A break or flaw in the ribbon heating element of a radiant surface element can prevent the surface element from heating properly. If a portion of the radiant surface element doesn't heat, replace the surface element.

A faulty control switch or failed surface burner relay control board can also cause surface element heating problems. If a surface element heats evenly but you can't control the temperature using the surface element switch, replace the surface element switch. Replace the relay control board is it doesn't regulate the surface element to produce the heating level you set.

A broken temperature limiter on a radiant surface element may shut off the element too soon, preventing the surface element from reaching the desired temperature. If the element cycles on and off frequently and doesn't reach the proper temperature when you choose the high setting, replace the surface element temperature limiter. The thermal limiter is sometimes included with the radiant surface element so replace the radiant surface element if the thermal limiter isn't available separately from the radiant surface element.

Cleaning grates and surface burners on your Fisher & Paykel gas range

• Cool burners and cooktop. Allow the burners and cooktop to cool before you start cleaning.
• Soak grates and burner caps overnight. Fill your kitchen sink with about 2 gallons of water then add 3 tablespoons of grate cleaner to the water. Stir the water until the granules completely dissolve. This stuff is strong, so wear gloves and avoid getting it on your skin. If you do, rinse it off. Soak grates and burner caps overnight.
• Clean softened residue. The next day, put on some rubber gloves and drain the sink. Using a scrub brush or abrasive pad, clean softened soil and residue from the grates and burner caps and rinse everything thoroughly. Wipe the grates clean with a towel.
• Clean the burner heads. First, wipe the burner head with a damp cloth. Remove food and residue between the burner head slots using a toothbrush. To remove stubborn residue, use a paper clip or sewing needle. A small-gauge wire works also. Make sure that you clean the ignition port so the burner ignites properly. Wipe the burner head with a damp cloth after cleaning the slots and the ignition port.
• Allow all burner heads to dry and then reassemble the range.