Haier  Washer  Front-Load Model Error Codes

These error code explanations can help you diagnose a problem with your Haier front-load washer.  For repair how-to help, visit the PartsDirect repair help section, which includes repair help for washing machines, other major appliances, lawn and garden equipment, garage door openers, vacuum cleaners and more. You can also search for owner’s manuals and find washer replacement parts

Check out our washer error code charts for information on a different brand of washer.

Error Code Condition Check/Repair Shop Parts
bLoC PunP Water not draining Remove any clogs from the house drain for the washer. Remove any clogs or kinks from the washer drain hose. Unplug the washer and check the large-item filter in the drain pump for a clog. If the drain pump is defective, replace it.
Drain pump
no tAPS Not filling Fully open both water supply valves behind the washer. In winter, check the fill lines for freezing. Check the drain system for a siphon problem. If the water inlet valve assembly is defective, replace it.
Water inlet valve assembly
Err7 Motor speed error Unplug the washer and reconnect any loose wires on the drive motor. Replace the wire harness if damaged. If the wire harness connections are okay, replace the drive motor.
Drive motor
Err8 Washer overfilled with water Unplug the washer. Replace the water inlet valve assembly if the washer continues to fill when unplugged.
Water inlet valve assembly
ErLC or ErUL Door lock failure Unplug the washer and reconnect any loose wire harness connections on the door lock assembly. Replace the wire harness if damaged. If the wire harness is okay, replace the door lock assembly.
Door lock assembly, Wire harness
EUAr Communication failure between the display board and the power board Unplug the washer and reconnect any loose wire harness connections between the display board and the power board. Replace the wire harness if damaged. If the wire harness is okay, replace the display board. If the problem persists, replace the power board.
Display board, Power board, Wire harness
Unb Unbalanced load Redistribute the wash load and restart the washer.
PF Supply voltage is less than 93 volts AC Unplug the washer and replace the power cord if damaged. If the power cord is okay, have an electrician repair the power supply provided to the washer.
Power cord
CLrF Too much suds The washer adds water and gently tumbles the clothes to remove excessive suds. Use the right amount of high efficiency (HE) detergent to avoid excessive suds.
HE detergent