CONFIRM THE PART FITS

Home  >  Coil

Coil 685947

★★★★★★★★★★
5
0
4
1
3
0
2
0
1
0

Part #685947

Replaced by #279894
?
Manufacturer substitution
This part replaces 685947. Substitute parts can look different from the original.
Online Price
$217.58 | 
5% OFF 
MSRP: $230.00
In Stock
For ZIP codes near Edit
60-day return policy
This part fits

Part Information

This burner and gas valve assembly (part number 279894) is for dryers.

Dryer burner and gas valve assembly 279894 comes as a complete assembly: the burner that distributes the gas for an even flame, the valve that controls the flow of gas to the burner and the igniter that lights the gas to create the flame.

Unplug the dryer and shut off the gas supply before installing this part. Wear work gloves to protect your hands.

Top models using the same part

Model NameModel NumberDiagram Name
Model #1107109910 Kenmore laundry center1107109910
Burner assembly
Model #110349799 Kenmore dryer110349799
Burner assembly
Model #110694005 Kenmore dryer110694005
Burner assembly
Model #110688639 Kenmore dryer110688639
Burner assembly
Model #110689792 Kenmore dryer110689792
Burner assembly
Model #110349621 Kenmore dryer110349621
Burner assembly
Model #110343114 Kenmore dryer110343114
Burner assembly
Model #110687139 Kenmore dryer110687139
Burner assembly
Model #110279119 Kenmore dryer110279119
Burner assembly
Model #1107207210 Kenmore dryer1107207210
Burner assembly

Reviews

ljd1609
Montrose, Co.Reviews 1Votes 0
★★★★★★★★★★
• 5 years ago
ljd1609• 5 years ago
Quick and easy installation.

You only need a 5/16 nut driver, needle nose pliers, and an adjustable wrench for the gas fitting. Remove the lower pop-off kick panel and start the dryer. If the ignitor gets red hot, but no flame starts, the gas valve coil assembly is bad. In my case I had to change the complete unit because the older coils were no longer available. SHUT OFF THE GAS COCK AND UNPLUG THE DRIER. PLACE A THROW RUG ON THE FLOOR IN FRONT OF THE MACHINE BECAUSE YOU WILL BE LYING ON THE FLOOR TO DO MUCH OF THE INSTALLATION.

  1. Remove the two sheet metal screws at the lower front of the unit. 2) Slide off the two spade lug connectors from the high temp safety switch on the side of the flame tunnel. 3) Loosen the hex gas nut. 4) Unplug the electrical connector to the rest of the controls. The entire unit should now slide forward free of the machine. (Now would be a good time to grab the vacuum cleaner and eliminate as much dust and lint from the lower regions of the dryer as you can.) Prepare the new unit by installing the furnished new ignitior. (It may be flat or round.) Put the new ignitor in place using the old unit as a guide. (One sheet metal screw and one electrical connector.) You are now ready to install the new assembly. Reverse steps 4 thru 1. Turn on gas cock. (Soap bubble check for gas leaks. Fix any leaks found.) Plug in dryer and do a test run. If new ignitor gets red hot and gas jet ignites, you are done. Shut off dryer and replace kick panel.