CONFIRM THE PART FITS

Home  >  Control T08

Control T08 WB27X10129

★★★★★★★★★★
5
3
4
0
3
0
2
0
1
0

Part #WB27X10129

Replaced by #WB27X10311
?
Manufacturer substitution
This part replaces WB27X10129. Substitute parts can look different from the original.
Online Only Price
$206.19 | 
5% OFF 
Phone Price: $216.19
In Stock
For ZIP codes near Edit
60-day return policy

Only ground shipment is available for this item.

This part fits

Part Information

This oven control board (part number WB27X10311) is for ranges.

Oven control board WB27X10311 monitors the temperature and controls the oven heat.

Unplug the range or shut off the house circuit breaker for the range before servicing the unit. Wear work gloves to protect your hands.

Top models using the same part

Model NameModel NumberDiagram Name
Model #JBP78BY3 GE electric rangeJBP78BY3
Control panel & cooktop
Model #JBP30BA4 GE electric rangeJBP30BA4
Control panel & cooktop
Model #JBP66WY4 GE electric rangeJBP66WY4
Control panel & cooktop
Model #JBP66DY5WH GE electric rangeJBP66DY5WH
Control panel & cooktop
Model #JBP78AY4 GE electric rangeJBP78AY4
Control panel & cooktop
Model #JBP66BY4AD GE electric rangeJBP66BY4AD
Control panel & cooktop
Model #JBP76WIY4 GE electric rangeJBP76WIY4
Control panel & cooktop
Model #JBP75AY3 GE electric rangeJBP75AY3
Control panel & cooktop
Model #JBP30AA4 GE electric rangeJBP30AA4
Control panel & cooktop
Model #JBP66BY5WH GE electric rangeJBP66BY5WH
Control panel & cooktop

Reviews

Vern
Livonia, MI.Reviews 1Votes 0
★★★★★★★★★★
• 2 years ago
Vern• 2 years ago
Easy to install

It is a revised part from the original but was still easy to replace with included wiring instruction sheet. You do need to remove the plastic terminal body from the bake element wire to allow it to plug into the new circuit board, I did wrap the terminal with electrical tape to provide some protection after body removal. You also need to transfer the control button plastic membrane on the face of the control board to the new board. I used a heat gun on low heat and a putty knife to CAREFULLY release the membrane from the adhesive, do not let it get to hot, it will cause the membrane to warp or melt. After removal I cleaned off the remaining adhesive from the membrane and applied new double sided tape and I aligned attached to new board using the raised bosses on the board as a locator guide. Transferring the membrane was the most time consuming part of the repair.

Jake
MinnesotaReviews 1Votes 0
★★★★★★★★★★
• 2 years ago
Jake• 2 years ago
Simple to install

Easy installation, instructions didn't match part exactly but with only 4 wires it wasn't a problem.

Dave L
Waverly ohioReviews 1Votes 0
★★★★★★★★★★
• 2 years ago
Dave L• 2 years ago
Straightforward great instructions

Great instructions, easy job, would use sears again!