Model #YY-80-DA Amana misc hvac

  • Replacement Parts
    3 Results

Question and Answers

Q:

Why is my Electric Range Flashing F7 DA?

A:

Thank you for your question.

I can understand wanting to know what F7 means on your G.E. range.

  • The F7 code means you have a stuck key on the touch pad interface.

  • Is the DA part of the error code because if it is I do not know what that means.

  • Sometimes you can rub back and forth across the touch pad an get it to release. You also can remove the ribbon harness from the control board and put it back in, and it will sometimes work.

  • Disconnect the power to the range and reconnect after one minute. If the error code reappears you will need to have the touch pad/and or the control board replaced.

I would suggest that you have a technician check to see which one it may be. These parts are pretty expensive and it would be good not to have to replace both.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
November 06, 2010
Q:

I replaced the swivel on my 11622613205 vacuum. I connected wires (y-y, w-w, b-b). It doesn't work. Can you help?

A:

The connections y-y, w-w, b-b, are correct. A wire might have gotten disconnected from the switch or motor in assembly.

I am sending you a wiring schematic for the vacuum. If we can help, send another email.

Read More
Jimmy K -
Sears Technician
October 21, 2009
Q:

Kenmore Series 80

A:

If you spin the input shaft in the correct direction it should cause the agitate shaft to move. If it does not move it very well could indicate a gear case failure. NOTE: Be sure the motor coupler was not broken that links the motor to the gear case. If the motor coupler is broken it will not agitate or spin.

Read More
Joey S -
Sears Technician
July 20, 2010