Model #XR-34 Brother mechanical sewing machines

  • Left Side Assembly
    3 Results
  • Right Side Assembly
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I replaced the heating element on a whirlpool built in electric oven but the new element does not work. Are there other parts that tipically go bad?

A:

You could have blown oven shut-down thermal fuse in that circuit. The wiring diagram in the first image below shows that component circled in red for the upper oven. The lower oven has a similar fuse. The physical location of those fuses is shown in the second image. You would need to shut off the house circuit breakers for the oven and pull it out of the cabinet to access those fuses. They are located on the outside back wall of the oven cavity. Remove the outer back panel on the oven to access that component. If those fuses are okay, then you could have a bad relay on the electronic oven control board. The relays are circled in green and blue. The location of that control board is in the console. It is mounted behind the control panel. A wiring failure in that circuit could also prevent the element from heating.

You can order parts from this page: Whirlpool Oven Model GBD307PDS09 Parts . Be sure that you shut off the house circuit breakers for the oven before accessing internal components and replacing parts.

I hope that this information helps. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 20, 2012
Q:

What was the original price for a craftsman table saw xr 2412 (113.298032)? How much did it weigh and does it have a cast top?

A:

That saw retailed for $399.88. I don't have a specification on the weight but it is probably close to 300 lbs. It does have a cast iron top.

Read More
Lyle W -
Sears Technician
May 09, 2013
Q:

How do I get the saw to change the angle of the miter cut? 8323 Tradesman Miter saw

A:

Thank you for your question and I understand your concern.

In order to change the angle of the miter cut you will need to loosen the locking handle knob, push down on the lock lever above the locking handle knob and then the table should rotate. If it does not rotate, the table is likely jammed. I added an image below to reference. 

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
May 01, 2013