Model #XL-3010 Brother mechanical sewing machines

  • No Image Available - Wards
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

craftsman gt 917259011 with transaxle 218 3010

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. I have looked up the model number you have submitted the original part number of the transaxle was substituted to 163198. According to the information we have, these two transaxles are interchangeable.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
July 14, 2011
Q:

where are the fuses in a GE Spacemaker XL?

A:

There are typically several internal fuses in the microwave but these are components that should only be accessed by a service technician.

The nature of your question indicates that the microwave may not be powering up. If this is the case, here are some tips that may help:

  • Make sure that the microwave is properly plugged into the outlet (usually in the cabinet above the microwave).

  • Check the house circuit breaker for the outlet that the microwave plugs into to make sure that it is not tripped.

  • Plug a small lamp or appliance into the outlet for the microwave to make sure that the outlet is working.

If these tips don't help, then you will likely need to have the microwave serviced. Microwaves are inherently dangerous to service due to high voltage components that can retain a lethal electrical charge even when the unit is completely unplugged. The microwave must also be checked for microwave leakage following any internal component repair. These are the reasons that a technician should complete any internal component repair (including internal fuses) on a microwave. Here is a link for the Sears Service website in case you need it: Sears Home Services .

NOTE: It may be more economical to replace the microwave instead of repairing it.

Read More
Lyle W -
Sears Technician
July 29, 2010
Q:

Why won't my GE XL 44 gas oven light?

A:

Without a model number, I will only be able to provide general troubleshooting and advice for this problem. When you set the range for baking, you should hear a relay click on the electronic range control board. It will be the same type of click that you hear when you set the range to broil. If you do not hear this click of the bake relay, then the electronic range control board is bad and will need to be replaced.

If the relay does click, then your likely failure would be one of the following:

  • Failed glow bar igniter
  • Defective safety/gas valve
  • Wiring failure between components
I recommend calling a service technician to diagnose and repair these types of failures.

If you want to attempt this repair yourself and you need more help, resubmit your question with the full model number of your GE XL 44 Spectra range.

Read More
Lyle W -
Sears Technician