Model #WSK-3300 Thermador dishwasher

  • Tank/baskets
    3 Results
  • Detergent Cup
    3 Results
  • Control Panel/float Switch
    3 Results
  • Motor/gaskets
    3 Results

Question and Answers

Q:

ignition module wiring on poulan 3300 3300 Poulan 16" chain saw

A:

Thank you for your question.

 

I am sorry you are having a problem with the chainsaw. I will be happy to assist you. I looked up the model number you submitted. It looks like this model has one wire connected to the ignition coil and another wire connected on or near the ignition coil mounting screw. These two wires are part of the engine kill circuit. They run down to the on/off switch. The switch has two terminals on it. One wire connects to one terminal and the other wire to the second terminal.  When you turn the switch off, it completes the path to ground and the engine will turn off.

I hope this is helpful. Please let me know if you need further assistance.

 

Thank you for using Manage my life.

Mark

Read More
Mark T -
Sears Technician
September 17, 2013
Q:

Kenmore Electric Range Broil Element

A:

I am sorry to hear about the problem that you are having with your Kenmore Range Model 665.92173300.

 

The location of the thermal fuse for the broil element is shown in the image below. You can unplug the range and access that fuse as shown below. You can check to see if a blown fuse is causing your problem by connecting the wires that go to that fuse together and taping them with electrical tape so the wires don't short out to the metal cabinet. Reassemble the range and plug it back in. Briefly start the oven in the broil mode to see if it heats properly. Make sure the broil element cycles off properly when the interior oven temperature heats up to 500 degrees (close the oven door so that the oven sensor will detect that temperature in the oven cavity). If the broil element works properly during that brief test, then you should be able to fix your problem by replacing that thermal fuse. Do not continue to operate the range with that thermal fuse bypassed. Restore the original wiring configuration to that fuse and order the replacement part. You can order that fuse from this page: Thermal Fuse Part 3196548 for Kenmore Range Model 665.92173300.

 

Be sure that you unplug the range before accessing internal components and replacing parts.

 

Note: If that thermal fuse was blown, you will normally need to determine what caused that fuse to blow if possible before replacing it. A bad relay in the control board, a short in the wiring or a problem with the broil element could cause that failure. There are times when the thermal fuse will blow due to a "nuisance trip" where the fuse experiences high temperature due to broiling items that have a high fat content. If you suspect that the fuse was blown due to a nuisance trip, then replacing the fuse should fix your problem without further component diagnosis and repair. 


If the broil element does not heat after bypassing that thermal fuse, then you may have a failed broil element (even though it does not appear to be broken), a wiring failure or a problem with the electronic oven control board in the console. Reply with additional details if you need more help diagnosing and repairing this failure.

 

If you get to the point where you need to have a service technician examine and repair the range, you can schedule service through this link: Sears Home Services Range Repair. 

Read More
Lyle W -
Sears Technician
April 17, 2013