Model #WFW8300SW01 Whirlpool residential washers

  • Cover Sheet
    3 Results
  • Top And Cabinet Parts
    3 Results
  • Door Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Can I get a Code book on line

A:

Thank you for your question and I understand your concern.

The "F20" fault code indicates no water is entering the washer or it taking longer than 6 minutes to fill and trip the water level pressure switch. The "F20" fault code is usually displayed when the water supply is restricted. Turn the hot and cold water supply valves off and then remove the hot and cold fill hoses from the back of the washer. Look inside the ports of the hot and cold water on the back of the washer and see if the filter screens are restricted. Clean the debris from the screens but do not leave the screens removed. Confirm the hot and cold water supply is adequate by placing the ends of the hoses in a bucket and turn the water on. If you have adequate water pressure and volume, you may need to replace the water inlet valve assembly on the washer.

I added an image below of the list of fault codes.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 06, 2012
Q:

Why is my washer flashing "F21"?

A:

I added a link below with the explanation and causes of "F21". The link below is not your exact model but it will address your problem.

Why is my washer displaying "F21"?

Read More
Joey S -
Sears Technician
February 27, 2009
Q:

How do I replace the rubber seal around the front opening of my Whirlpool front load washer?

A:

The procedure for changing the gray rubber door seal on this model of Whirlpool washer is shown in the images below. Be sure to unplug the washer before beginning this procedure. The basic procedure involves these general steps that are described in the images below:

  1. Unplug the washer and shut off the water supply.
  2. Remove the top panel.
  3. Disconnect the wire harness for the console.
  4. Remove the console as shown below.
  5. Remove the bottom front service panel.
  6. Remove the spring clamp on the front of the bellows (gray rubber door seal) as shown below.
  7. Push the bellows into the washer tub.
  8. This will give you access to the door latch assembly so that you can remove it or disconnect the wiring so that the front panel can be removed. Disconnect or remove the door latch assembly.
  9. Remove the front washer panel as shown in the second image below.
  10. Remove the clamp that secures the bellows to the washer tub and take off the old bellows.
  11. Follow the tips in the third image below and the first image to properly secure the new bellows.
  12. Reverse the above procedure to reassemble the washer.
This is a long and fairly complex procedure. Make sure that you thoroughly read and understand the steps before beginning the process. If you need help, resubmit your question with additional details and we will help you further.

Read More
Lyle W -
Sears Technician
May 08, 2009