Model #WA27M8WAFB Gibson washers

  • 3 Results
  • Cabinet Parts
    3 Results
  • Tub Detail
    3 Results
  • Transmission Parts
    3 Results
  • Console And Control Parts
    3 Results

Question and Answers

Q:

I need to replace the idler arm assembly (Part #131862900) for a Gibson Top Load Washer M#WA27M8WAFB, S#XC33428942. I have the part but don't know

A:

Thank you for your question on the replacement of the idler belt pulley.

First you will need to unplug the washer.

Then remove the lower panel on the washer.

Push in on the belt tightener and roll the belt off the motor and transmission pulleys.

Locate the pivot pin location and remove the C clip on the bottom side of the shaft. Be careful not to loose this clip.

With the belt rolled off you should now be able to remove the idler.

I have given you more instructions and a picture below.

I hope this will help you.

Sam A.

Read More
Sam A -
Sears Technician
November 25, 2011

Recommended maintenance parts & accessories

Show 3 more
No more item to show