Model #WA-1 Lobb humidifier

  • Replacement Parts
    3 Results

Question and Answers

Q:

Can I change the air gap to under the counter ( new sink)

A:

Here is a direct link for the installation guide for this model of dishwasher: Installation Instructions . NOTE: It may take a minute or two for the installation guide to load up. Let me know if you still have problems accessing the installation guide.

The installation guide shows several options for installing the drain hose. It shows the procedures for installing the drain hose without an air gap. NOTE: Local plumbing codes in some areas require an air gap to be installed on the drain line of a dishwasher. You may need check with a plumber in your area before eliminating the air gap. The plumber may have other options that comply with local codes.

If there is not a code requirement for an air gap, then you can connect the drain line as shown in the installation guide provided above.

I hope that this information helps. If you need more assistance, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
January 28, 2011
Q:

How do I fix my Craftsman Professional floor jack that is leaking hydraulic fluid?

A:

I am not able to determine the model of Craftsman Professional floor jack that you have based on the numbers that you submitted. The numbers do not match up to valid model numbers.

I recommend that you have this type of product serviced by a technician.

Without a model number, I cannot see the warranty on this item.

I do not see a service center near Vancouver, WA. You can normally take an item to any Sears store for service. If they do not have a service facility at the store, they will normally ship the item off for service. I recommend contacting your local Sears store to arrange service for this floor jack.

Read More
Lyle W -
Sears Technician
October 13, 2009
Q:

my lanwmower wont stay running because the choke will not stay open someone changed the carberator on it is there wa way to keep it open?

A:

Without a model number, I can't see what kind of carburetor or choke you have.

On some mowers when you move the throttle lever to advance the speed, the choke is opened by the carburetor linkage. There is no way to keep this from happening.

Be sure the gas in the lawnmower is not older than 5 weeks or has fuel stabilizer in it. Old or bad gas will cause the engine to die when it accelerates. The carburetor might also need cleaning or rebuilding.

Read More
Jimmy K -
Sears Technician
June 04, 2010