Model #U31FY-8X-CV Magic Chef range (gas)

  • Control Panel
    3 Results
  • Body
    3 Results
  • Control System
    3 Results
  • Door
    3 Results

Question and Answers

Q:

Oil Leak CV 16

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. I will be happy to assist you with the repair. I recommend checking the smell and the level of the oil. If the engine is over filled and smells like gas the problem is in the carburetor. If the oil smells, fine but over filled just drain some out. Once you have the oil level adjust, check the air filter. If it is oil soaked, replace the filter, and check the operation. The engine will likely, smoke for about five minutes. If it still leaks, the problem could be a failed breather or worn engine. You will need to do some further checks to diagnose this problem.

I hope this is helpful. Please feel free to reply below if you need any further assistance.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 22, 2012
Q:

What causes an 8x blinking led error on a Sony Bravia?

A:

The error suggests that the audio circuit might be damaged. Technology has made the size of these components so compact that traditional component level repair is usually not an option. The circuit board most likely to be required is the AU board. I recommend you visit Sears repair site here to get an estimate for a home diagnostic to confirm this. There the tech will confirm the need of the part and give you a cost of the part to your area. I tried to link it from our parts site Sears Parts Direct but was unable to find it listed.

Read More
David A. - Personal Solutions Manager -
Sears Technician
June 27, 2009
Q:

On a Kohlor CV 460S can a worn slot in my flywheel be shearing keys. I have gone thru 4 keys now.

A:

If the slot on the flywheel is worn enough to let the key move, it can cause it to shear. You can replace the flywheel without replacing anything else.

The most common cause for flywheel keys to start shearing after 1 has been replaced is the torque of the nut that holds the flywheel on.

The flywheel nut needs to be torqued to 300 inch lbs. This equals to 25 ft. lbs.

In order to get the nut that tight, someone has to hold the flywheel with a screwdriver jammed in the ring gear on the flywheel.

Read More
Jimmy K -
Sears Technician
June 03, 2009