Model #TRIMMY H2 Husqvarna trimmer head

  • Page 1
    3 Results
  • Page 2
    3 Results
  • Page 3
    3 Results
  • Page 4
    3 Results
  • Page 5
    3 Results

Question and Answers

Q:

H2 dryer wll work but will not heat.

A:

Thank you for your question and I understand your concern.

There are two components on the blower, a thermistor and the other one is a thermal fuse. If the thermal fuse fails, the motor will not run. If the thermistor fails open or shorted, it would display a fault code of "F22" or "F23".

The dryer likely has a faulty thermal cut off. See image below. The image below will have the diagnostic steps for diagnosing a no heat symptom. NOTE: Disconnect the power cord from the power source before diagnosing the failed part.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 31, 2012
Q:

Kenmore H2 plus washer, Model # 110.47512602

A:

That link for a previous answer that Julio posted in the above response has some information about that F28 code and provides some troubleshooting tips. I recommend that you unplug the washer and check the wiring connections between those components as described in that previous answer. If you find no problems with the wiring connections, then I recommend that you reply to this thread for further technical assistance if you want to fix this problem yourself. You could have a bad electronic control board or a failed door switch that could cause this problem.

This particular failure in the washer is often difficult to diagnose and repair. If you get to a point where you need to have a service technician examine and fix the washer, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 14, 2012
Q:

I have a Kenmore h2 Dryer and it runs but will not heat?

A:

Thank you for your question and I understand your concern.

Thank you for adding the model number of your dryer to the thread. I see you have an electric dryer. The heating element requires 220 volts in order to heat. The first thing to check and confirm is the voltage supply where it connects to the back of the dryer. When placing the voltage meter leads across the two outside terminals the voltage must measure 220 volts. If it measures 220 volts then it could have a faulty heating element, electronic control, faulty thermal cut off or high limit thermostat. See image below.

The heating element, thermal cut off and high limit thermostat can be disconnected and tested for continuity with an Ohm meter. NOTE: I do not recommend checking voltage unless you have experience and feel safe and confident in doing so, otherwise I recommend calling a service technician to diagnose your dryer.

I added a YouTube video showing how to test the thermal fuse if you feel confident in repairing your dryer. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 30, 2012