Model #TDS-4000 Ryobi screwdriver cordless

  • Cordless Screwdriver
    3 Results

Question and Answers

Q:

Craftsman DYT 4000 mower.

A:

Thank you for your question on the removal of the fuel line.

If you could reply with the complete model number from under the seat I will be able to give you more detail as to how much you will need to remove to replace the fuel line.

If the fuel goes into the top of the tank you may have to remove the seat pan to get to it. If it comes off the bottom of the gas tank you should be able to get to it above the transmission.

Please let me know what you find.

Sam A.

Read More
Sam A -
Sears Technician
March 27, 2012
Q:

Maytag Series 4000

A:

Thank you for your question and I understand your concern.

Based on the fault code "F21" if the drain pump is clean of debris and the drain pump is operating and pumping the water out, the "F21" could be displaying because the water level pressure switch is not detecting the water has been pumped out. If the pressure switch air hose is restricted; it could possibly cause the "F21" to display because air is trapped in the air hose or where the air hose connects to the air trap. The air trap is located at the rear of the tub near the bottom. If the small port the air hose is connected to is restricted, it could cause an intermittent "F21" fault code.

The "F21" will normally display if the drain time exceeds eight minutes and the drain pump will stop operating. Pressing Pause/Cancel should turn the drain pump back on and drain providing the there are not restrictions between the tub hose and drain pump. You did not mention if the drain pump will operate or not. We need to make sure the drain pump is actually running and not just making a humming noise.

Here is a list of the possible causes and procedures:

  1. Check the drain hose and make sure it is not plugged or kinked.
  2. Unplug washer or disconnect power.
  3. Check the drain pump filter for foreign objects, and also make sure the hose from the tub to the pump is not plugged or kinked.
  4. Check the electrical connections at the pump and make sure the pump is running.
  5. Plug in washer or reconnect power.
  6. If the above does not correct the problem, go to step 7.
  7. Unplug washer or disconnect power.
  8. Replace the pump.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
August 17, 2012
Q:

blade engage switch

A:

Thank you for you question.

I am sorry you are having a problem with the tractor. With the limited details, I am not sure what is going on with the tractor. If you could please reply below with more details and a model number, I will be happy to assist you.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 10, 2011