Model #T2-AABC-1X1A-1GX1 Hydro-gear transaxle/transmission, tractor

  • Transaxle
    3 Results

Question and Answers


One of my garage door sensors is broken. Is there a way to bypass these?


Congratulations on trying all the correct possibilities to by-pass the door sensors.

The programming in the logic board of your garage door opener is such that it is impossible to bypass the sensors.

You can force the door to open or close by holding the wall switch in.

Read More
Jimmy K -
Sears Technician
May 19, 2008

Why do I get the sp error code displayed on my Kenmore Elite washer mod 110.22054100 during the diagnostic test?


Since the basket will not spin at medium speed in the Recirculation Pressure Switch Test, the control may be signaling the sp for this reason. The sp code is not indicated in any of the technical information for this washer.

I recommend that you conduct the Pressure Transducer/Agitate Test and the Neutral Drain/Spin Test to see if the motor will run and the washer will properly agitate, spin and drain. This may better point you to your failure.

A problem with the lid switch or other components could be preventing the washer from running after filling. I provided additional technical information in the images below that may help you further diagnose the washer if needed. You can check the lid switch by accessing it (with the washer unplugged ). See if it is activating properly when the lid is opened and closed. If not, you may need adjust the actuator. You can also insert as insulated jumper wire as shown below to temporarily bypass it to see if this component is preventing the washer from spinning. You can also test the washer motor using the information below. NOTE: This information is intended for technicians. Follow electrical safety guidelines when using this data. Unplug the washer and shut off the water supply before accessing internal components. If you are not completely confident in your technical ability to use this information then I recommend that you call a service technician to fix the washer.

This is a complicated washer to diagnose and repair yourself. Properly diagnosing it may take several more questions and and answers before we can help you determine the cause of your problems.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
March 09, 2010

Accessories for table saw model 315.228310


Thank you for your questions on the accessories for your table saw.

The Delta T2 is a Biesemeyer clone. I believe that the company that owns Biesemeyer also owns Delta and other manufacture brands.

It looks like a nice fence system.

Here are some links for accessories for your saw.

O tolerance blade insert .

Dado insert .

XRC fence system .

Cast spider extension table .

Hear are a few of the accessories that are still available for this saw.

I hope this will help you.

Sam A.

Read More
Sam A -
Sears Technician
September 21, 2011