Model #SVD48600B Jenn-air slide-in range, electric/gas

  • Control Panel
    3 Results
  • Top Assembly
    3 Results
  • Door
    3 Results
  • Access Panel
    3 Results
  • Wiring Information
    3 Results
  • Oven
    3 Results
  • Body
    3 Results
  • Gas Controls
    3 Results
  • Blower & Convect Assy.
    3 Results

Question and Answers

Q:

Jenn-Air stove model SVD48600B

A:

Thank you for your question and I understand your concern.

You did not state what the original problem was with your range and I do not understand why the fan and oven light would come on after installing the new control when the power supply was turned back on. You also did not mention if the control accepts the command for bake or broil. If the new control accepts the command and the oven will not heat could also mean a faulty gas valve or igniter. If it will not accept commands then it may have a faulty touch panel. I will need more details in order to have a full understanding of the previous symptom(s).

The oven also has a relay board which actually controls the oven light and fan when it receives the command from the control board. It sounds like if the new control board is the correct one and it's wired up correctly then it may have a faulty relay board. The light and fan relay points could be stuck closed.

I highly recommend calling a service technician to properly diagnose and repair your range. You do not want to purchase and install an expensive control and not fix the problem. It can get costly and electrical components are not returnable once they have been connected/installed.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
June 08, 2011
A:

Anonymous: Double check all the connections on the new board. Disconnect and reconnect the wires and plugs and then see what happens. It seems now that you may have a faulty touch panel and possibly a faulty control or relay board. I highly suggest calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
June 09, 2011
See more answers
Q:

How to replace the oven temperature sensor in a Jenn-Air dual fuel slide in range?

A:

The oven sensor probe (key312) is located inside the oven cavity in the rear upper left hand corner. Remove the two (2), 1/4 inch hex head screws; pull the oven sensor into the oven cavity to gain access to the electrical quick connector. Disconnect the quick disconnect plug and reverse the procedure to replace and install. See image below. The oven sensor probe is part #12001656

Read More
Joey S -
Sears Technician
September 29, 2009
Q:

Conversion from propane to natural gas? SVD48600B Jenn-air Gas/electric slide-in range

A:

The installation guide provides instructions for converting the range back to natural gas. Here is a link for that installation guide from the Whirlpool.com website: Installation Manual for Jenn-Air Range Model SVD48600B . Page 8 of that manual provides the procedure for converting that range back to natural gas. Page 5 shows how to convert the pressure regulator on the range back to natural gas.

Note: A qualified installer should complete this conversion.

I do not see the natural gas orifices available for that range in the parts listing. The installer will normally be able to drill new orifices based on the orifice information provided on page 8 of that installation guide.

You can contact your local gas provider for a qualified installer. You may also be able to find a pre-screened service provider on the ServiceLive.com website.

Read More
Lyle W -
Sears Technician
October 22, 2012