Model #SUMMIT 650 NG Weber grill, gas

  • Replacement Parts
    3 Results

Question and Answers

Q:

Kenmore NG grill 141.17228.

A:

Thank you for your question.

I can understand wondering why you do not have any gas going to the grill burners.

You have no gas flow at all or just a little with very small flames?

Since this is a NG grill it will have no regulator at on the pipe from the connection to the grill.

Are you sure you have gas available at the gas port outlet. It could have a remote valve that has been turned off.

If you do not have gas available at the outlet you may have to contact the gas company or look for another valve to the supply line.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 14, 2011
A:

Thank you for the update. If you have gas right to the gas line connection on the grill then either all the valves are not working or you have some kind of blockage in the manifold that feeds the gas burner valves. Is it possible that the gas line system was let open at one time? Sometimes nests will get built in the tubes. But is none of the burner valves will feed gas to the burners it has to be in the manifold that the hose and the valves it attaches too. Please reply after you take that system apart. _ WARNING _! Please make sure when take the fittings apart that you seal them with pipe sealant when you put them back together. We do not want any leaks. Sam A.

Read More
Sam A -
Sears Technician
April 14, 2011
See more answers
Q:

converting range from lp to NG

A:

Thank you for your question and I understand your concern.

I added an image below that may be of help. I was not aware the orifice sleeve was removable. The low simmer orifice should be removed in the same manner as the other three. See images below.

The bake and broil burner spuds are located where the gas line enters the bake and broil burners. I added a third image with a red circle drawn around the spuds.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
December 12, 2011
Q:

NG Stove Repair Kenmore

A:

Thank you for your question and I understand your concern.

 I do not have a clear understanding of the failure. Is gas not flowing to the top burner and the bake burner?

In order for the bake burner to ignite, the glow bar igniter must glow red and the igniter must pull enough current/amperage to open the oven safety valve. If the bake igniter is glowing red, the igniter is likely too weak to pull enough current to open the oven safety valve. If the bake igniter is not glowing, it could have a broken bake igniter, faulty oven safety valve or possibly a faulty electronic oven control. I added a couple of images to reference below. To access the electrode and wire connection to the surface burner, the small little screws securing the surface burner to the top must be taken out. Note: The little screws are prone to snap off if your not careful in removing the screws. I recommend calling a service technician to diagnose and repair your range.

To access the bake igniter will require removing the oven rack and the oven floor. 

The surface burner spark electrode must jump spark between the electrode and the burner in order to ignite the gas to the burner.  Whenever any one surface gas valve is turned to the "lite" position, all 4 surface electrodes should begin sparking.  The cost of repair will depend on what parts are faulty.  The repairs could cost as much as $400.00 or more to repair your range depending on the failures.

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
March 11, 2013