Model #SPA361-SERIES 3 Snapper walk behind lawnmower, gas

  • Loop Handle/control Series 3
    3 Results
  • Traction Control
    3 Results
  • Oil Tank
    3 Results
  • Fuel Tank
    3 Results
  • Rear Deck
    3 Results
  • Rh Pump
    3 Results
  • Lh Pump
    3 Results
  • Power Unit Idler
    3 Results
  • Engine
    3 Results
  • Traction, Rear Wheel
    3 Results
  • Caster, Wheel And Tire
    3 Results
  • 36" Mower Deck (adjustable Height)
    3 Results
  • 48"/52"61" Mower Deck (frame)
    3 Results
  • 48"/52"/61" Mower Deck (deck)
    3 Results
  • 36" Deck Idler
    3 Results
  • 48"/61" Deck Idler
    3 Results
  • 52" Deck Idler
    3 Results
  • Cutter Housing
    3 Results
  • Decal
    3 Results
  • Electrical Wiring (manual Start)
    3 Results
  • Wiring Schematic (manual Start)
    3 Results

Question and Answers

Q:

My dryer's light went out and now it won't start. It just gives a series of 3 short beeps. What is wrong?

A:

If you are talking about the light inside the tub, it won't affect the operation of the dryer.

When you get 3 beeps when you press a button it usually means a button is stuck in your touchpad. The three beeps is what you get if you press more than one button at a time. To repair the dryer you will probably have to replace the touchpad.

Read More
Jimmy K -
Sears Technician
May 22, 2008
Q:

Why does my bread maker stop in the middle of the cycle and flash a series of 3 "X's"?

A:

I don't see this type of problem addressed in the owner's manual. The owner's manual is all of the information that we have regarding this appliance. Make sure that you have the bread maker set properly. It does not have serviceable parts. If the bread maker is not working properly and it is beyond the 2 year warranty then it will need to be replaced.

In case you need the owner's manual, here is a link: Owner's Manual . (Make sure that the bread maker is not set for just dough on menu setting 10).

Read More
Lyle W -
Sears Technician
January 14, 2010
Q:

What is an error code 3 on my Kenmore Elite 420 Series Water Softener

A:

I am sending you a list of the fault codes for water softeners. The possible causes of the fault codes are listed from most likely to less likely

Read More
Jimmy K -
Sears Technician
April 27, 2010