Model #SCE30600B Jenn-air slide-in range, electric

  • Body
    3 Results
  • Oven
    3 Results
  • Door
    3 Results
  • Top Assembly
    3 Results
  • Control Panel
    3 Results
  • Drawer
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results

Question and Answers

Q:

Wiring for dual burnnur infinity switch on Jenn-Air SCE30600B rang SCE30600B Jenn-air Electric slide-in range

A:

Thank you for your question and I understand your concern.
 
I added an image below that may have better instructions. 
 
 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
April 11, 2013
Q:

What is the best way to remove the old control panel from the front of the stove

A:

The procedure for accessing that control panel in this range is shown in the image below. Be sure that you shut off the house circuit breaker for the range before accessing internal components. This information should help you with your repair. If you need more assistance, reply with additional details.

Removing that control panel can be difficult. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
July 05, 2011
Q:

How do I replace digital control panel circuit board on my Jenn-Air range?

A:

Your symptoms point to a bad membrane overlay assembly (control panel). The F-1 normally indicates a short in this assembly or the ribbon wire that connects to the control board. It is possible that the control board (part 71001799R) is okay and did not need to be replaced. Replacing the membrane overlay assembly part 71002233 will likely fix this problem.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
February 05, 2010