Model #RUD8050RD0 Roper dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results

Question and Answers

Q:

Why does the clean light blink 3 times and then shut off on my Roper dishwasher model RUD8050RD0?

A:

The tech sheet does not show a fault code indicated by the clean light flashing 3 times. If it flashes 7 times and repeats, this indicates a heating circuit fault. A constantly blinking light would indicate that you have a stuck key on the console.

Make sure that your control is not locked.

If the control is in a demo mode or is flashing the heater fault routine, you can reset the control by running the diagnostic test cycle as described in the image below. This test may indicate the cause of any problem as well if you can start this routine. If you are not able to start the diagnostic test cycle, then you likely have a problem in the electronic control board or the control console.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
September 28, 2009

Recommended maintenance parts & accessories

Show 3 more
No more item to show