Model #RS800 SD-P-LR Gen/tran transaxle/transmission, tractor

  • Transmission
    3 Results

Question and Answers

Q:

What does "LR" error code indicate?

A:

Without knowing the model number of your washer I will have to assume that it's a Maytag washer. The "LR" error code indicates a "Locked Rotor" This means it does not see the motor operating. If this is an intermittent code the likely failure is either a loose wire connection at the motor or at the motor control board. If the motor will not operate at all would likely indicate a failed motor control board.

I recommend calling a service technician to diagnose and repair your washer.

Read More
Joey S -
Sears Technician
April 17, 2009
Q:

What does "Sd" mean on my washer?

A:

The "Sd" error code is an indication of Suds Lock (overdose of detergent detected during the wash cycle).

High Efficiency (HE) detergent is recommended which is a low sudsing detergent. Note: Using too much of the recommended HE detergent will also cause too many suds and cause "Sd".

I recommend not adding any detergent and rewash the clothes that did not rinse well. You will most likely see a lot of suds indicating that you are using too much or the wrong kind of detergent.

Read More
Joey S -
Sears Technician
August 20, 2008
Q:

what is sd or 5d mean

A:

Thank you for your question and I understand your concern.

The "sd" indicates the oven control is in the Sales Demo mode.

A sales demo (SD) mode is available that allows the TSC panel functions to be demonstrated without turning on any heating elements.

To enter or exit the SD mode disconnect power to the range. Reconnect the power and within 45 seconds touch the "OVEN COOK TIME" keypad on the TSC panel and hold until "sd" appears in the EOC display (approximately 6 seconds). The time of day display will blink until the clock is set. In the Sales Demo mode all control panel and display functions can be demonstrated but the elements will not heat.

To exit the Sales Demo mode you must repeat the procedure used to enter the Sales Demo mode. Disconnect the power to the range; reconnect the power and within 45 seconds touch and hold the "OVEN COOK TIME" pad until the "sd" display disappears. You can not exit the Sales Demo mode by pressing the Stop/Clear keypad or by resetting the power to the range.

This may be the issue. If not, please reply and I will be glad to assist you further.

Read More
Joey S -
Sears Technician
November 06, 2012
A:

Jenn: Try using the "Bake Time" button in place of the "Cook time".

Read More
Joey S -
Sears Technician
November 18, 2012
See more answers