Model #R-175 Ryobi router

  • Plunge Router
    3 Results

Question and Answers

Q:

the flyweight on garbage disposal is loose . one is tight and one loose . can this flyweight be tightened and how do you do this. the disposal makes a clicking

A:

Thank you for your question and I understand your concern.

The clicking noise is likely being caused by a hard object stuck along the outer edge inside the disposal. You will likely have to locate and remove the object with long pair of hemostats.

The cutting blades should be loose so they can pivot in circles. If one is not loose enough to spin freely on the rotating shredder then it will need to be freed up. Try spraying some WD 40 or penetrating fluid on the cutting blade and let it sit for an hour or so. After letting it sit for awhile; start the disposal and turn the cold water on. While the disposal and water is running; drop 4-5 ice cubes into the disposal and it will likely free up the cutting blade as well as clean up the inside of the disposal.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
December 29, 2011
Q:

how do I R & R this part touchpad #97013466

A:

There is not a procedure available for the replacement of the touchpad on that older Kenmore range hood. These general tips may help you complete that repair:

Shut off the house circuit breaker to disconnect electrical power and remove the filter on the side that has that touchpad. You may be able to disconnect that wires and pull that touchpad out after removing that filter. If not, then you may need to remove the blower motor and/or other components. The owner's manual/installation guide will normally provide directions for removing the blower motor. You may need to pull the range hood down to access that touchpad. You can view the parts image for the blower on this page: Kenmore Range Hood Model 233.5548910 Parts . The parts diagram may help you access and replace that part.

If you get to the point where you need to have a service technician replace that touchpad, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 15, 2013
A:

Here is the image.

Read More
Lyle W -
Sears Technician
January 15, 2013
See more answers
Q:

Gas Footvalve R&R JGP330EP2BG

A:

Thank you for your question and I understand your concern.

Yes, the glass top must be taken off to access the burner valve. I added an image below with the procedure of removing the glass top. NOTE: Turn the gas supply off and disconnect the power cord from the power source before servicing.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
September 11, 2013