Model #R-1500 Sharp microwave/hood combo

  • Oven And Cabinet Parts
    3 Results
  • Control Panel/door Parts
    3 Results
  • Wiring Diagram
    3 Results

Question and Answers

Q:

PTO on Craftsman LT 1500

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. The deck on your tractor is engaged with a cable. With the engine turned off have someone engage and disengage the mower while you watch the cable and the idler arm. The cable pulls on the spring that pulls the idler to tighten the belt. If the cable stretches the spring but does not move the idler, I suspect the pivot point on the idler is rusted. Usually spraying the area down with WD-40 and work it back and forth. I hope this is helpful.

Please let me know if you need further assistance.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 17, 2011
Q:

DP gympac 1500

A:

Thank you for your request for a instruction manual for the old DP gympac 1500. I have looked a number of places but could not find the manual for this gym.

I found a lot of references to the manual but could not find the actual manual.

I would suggest spending sometime on the some search engine web sites and you may be able to find one.

Sears sold a number of models of the DP gym Pac but I do not see a reference to this model.

I am sorry that I could not help you.

Sam A.

Read More
Sam A -
Sears Technician
May 04, 2012
Q:

how do I R & R this part touchpad #97013466

A:

There is not a procedure available for the replacement of the touchpad on that older Kenmore range hood. These general tips may help you complete that repair:

Shut off the house circuit breaker to disconnect electrical power and remove the filter on the side that has that touchpad. You may be able to disconnect that wires and pull that touchpad out after removing that filter. If not, then you may need to remove the blower motor and/or other components. The owner's manual/installation guide will normally provide directions for removing the blower motor. You may need to pull the range hood down to access that touchpad. You can view the parts image for the blower on this page: Kenmore Range Hood Model 233.5548910 Parts . The parts diagram may help you access and replace that part.

If you get to the point where you need to have a service technician replace that touchpad, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 15, 2013
A:

Here is the image.

Read More
Lyle W -
Sears Technician
January 15, 2013
See more answers